Tuesday October 6, 2026 - Antique Tractors & Large Shop Auction

with three bolt holes on top for attaching to a drawbar or implement frame; below it, a forged jaw/yoke with a pin hole for a hitch pin, cushioned by

Rust staining and an orange/yellow residue mark visible near the top edge; overall surface shows light rust and weathering consistent with the other g

Galvanized gray finish with a rust-stained seam line running the length of the body and light surface rust and grime overall. A flat, angled metal bra

It shows wear consistent with age and use, including surface rust, paint loss, and dirt. The assembly appears complete as pictured, but function of th

Vintage 18-inch pressed steel V-belt pulley in original red paint, with two belt grooves. It has a recessed center with a 3-bolt mounting pattern and

It shows heavy surface rust with traces of old blue-gray paint. Some of the mesh screening near the bottom is torn or missing, and the lower center ed

They are in good overall condition with paint wear, light surface rust, and dirt. One bolt hole has a remnant of old hardware in it. No cracks or chip

The tires are dirty but still hold their shape, with the tread lugs intact. The wheels show surface rust and paint wear. The red part has good paint c

Vintage belt-driven burr mill (grist/feed mill), suitable for grinding corn, grain and feed. Heavy cast iron construction with a pedestal base and bol

Ridgid ratchet die handle: Marked "Ridgid", with traces of the original red paint and a long handle. Ratchet pipe threader die head: Adjus...

Two vintage cast iron screw jacks, suitable for tractor, implement, automotive or display use.

Vintage cast iron right-angle gearbox in red, for PTO-driven equipment. It has a horizontal splined input shaft (appears to be a standard 6-spline PTO

Red double-acting hydraulic cylinder for a tractor or implement. Not tested; condition of the seals is unknown. Sold as is, where is. Please look at a

Heavy-gauge red sheet metal shield or cover panel, formed with rounded bends and pre-drilled mounting holes. It looks like a guard or cover from a vin

Good for a belt-pulley project or a display with antique equipment, or as a replacement belt for a restored machine. Not tested; sold as is, where is.

Pair of long Parker hydraulic hoses. The hose print reads "Tough Cover 451TC-8", which is 1/2" hose. Both hoses have crimped fittings...

Assorted vintage tractor lighting parts, mostly in red paint, suitable for restoring or repairing older tractors

Flat, heavy steel plate in a crescent (kidney) shape, with a large half-round cutout and several pre-drilled bolt holes around the cutout and across t

The paint is worn, with bare metal showing on the high spots. The mesh is worn and torn in places. It would suit restoring a vintage tractor, or it co

Three vintage tractor DC generators, sold together All three show age, rust and dirt from storage. Good as rebuildable cores or for parts, or for rest

t could work as a rake or grapple head for clearing brush, roots or debris, or be mounted to a bucket, hitch or handle. It would also make an interest

Two vintage tractor generators, likely 6-volt DC:

The pin threads in and out, and the shackle appears straight and in good usable condition. Sold as is, where is. Please look at all photos closely.

Complete-looking vintage oil bath air cleaner assembly in red paint for a tractor. It includes: Canister body: Has two band clamps and a bottom oil c

There is light wear and paint chipping, and more rust and grime around the fan and drive ends. Good as spares or rebuildable cores, or for restoring I

The wide crowned face suits flat drive belts. The paint is worn, with surface rust, dirt and patina. The splines look clean and intact. Good for resto

An assorted lot of vintage tractor engine and air-intake parts, mostly in red paint Condition ranges from good paint to worn, with surface rust and ch